How to Replace a Kilner Stainless Steel Tap

Quick Answer

To replace a Kilner stainless steel tap, remove the old tap, clean the hole, and press the new tap firmly into place. The tap fits Kilner 3, 5, and 8 litre drinks dispensers, and a secure fit prevents drips.

Step-by-Step Replacement

1. Empty and rinse the dispenser: Pour out any remaining liquid and rinse the dispenser with warm water. This makes the tap easier to see and work with, and prevents spills. Check that the area around the tap hole is dry before you start.
2. Remove the old tap: Grip the old tap firmly and pull it straight out of the hole. If it is stuck, twist it gently while pulling. Do not use excessive force, as you could crack the glass. If the old tap breaks, remove any remaining pieces carefully and check the hole for damage.
3. Clean the tap hole: Wipe the hole and the surrounding glass with a clean, damp cloth to remove residue or debris. A clean surface helps the new tap seal properly. Let the area dry completely before inserting the new tap.
4. Insert the new stainless steel tap: Align the tap with the hole and press it in firmly until it sits flush against the glass. You should feel it click or seat securely. If the tap feels loose, remove it and check that no old seal or debris is blocking the hole.
5. Test for drips: Fill the dispenser with water and open the tap. Let it run for a few seconds, then close it and check for leaks. Wipe the area and observe for a minute. If it still drips, the tap may not be seated fully; press it in again or check for damage.

Product to Use

• Kilner® Stainless Steel Tap: Made from stainless steel, this replacement tap allows liquid to flow freely without any drips. Suitable to fit the Kilner 3, 5 and 8 litre drinks dispensers. This tap is a direct replacement for Kilner dispensers, so you can swap it out without needing extra adapters or tools.